At the time of the low productivity of the community, wood stripping work is done manually, with the improvement of productivity, timber industry upstream downstream efficiency improvements, wood hand-peeling more and keep pace with the timber industry's average productivity, become the bottleneck of restricting timber trade, so the first generation timber wood Barker Barker-ring came into being. Wood stripping machine by hand into the machine age.
In a very long time in circular wood debarker to meet the people's demands, and because higher stripping ratio, a wood debarker, mainstream. However, social progress, productivity has increased, circular wood debarker due to its structural limits the productivity and efficiency, larger and because of the damage to the wood, timber equipment were out of the mainstream. Second generation of wood wood Barker Barker-drum began to rise.
Drum wood stripping function once in a lot of wood, its productivity more ring-type peeling machine has been greatly improved. But because it put in and take out of wood to stop abuses also limit the prospects for drum-type peeling machine. Gradually out of the wood stripping machine. This third-generation wood stripping-machine-slot wood peeling machine.
Slot-type peeling machine use roller-type peeling, structurally simple and sturdy, strong rigidity, low failure rate, long service life. It consists of stripping rollers, feed the mouth, skin, wood, power transmission installation consists of five parts. Breaking the traditional drum peeling machine for wood, leaves the material disadvantage, feed must be shut down. Separation and wood veneer exports exports to achieve continuous work, feeding → skin → from wood-feeding → skin → → to wood the whole process on a continuous basis to achieve flow. Different kinds of wood, peeling effect can be adjusted lumber vary in length, bent screw wet/dry on the different skins. Single job you can peel 35-50 tons of wood a day, greatly saving manpower.
Trough-type peeling machine is developed on a foundation of foreign models of the new generation of high efficiency wood stripping products, the machine is used with ladder-type stripping teeth of the unique force of the rotor, the wood within the silo trough plate do cycle movement and rotation around the axis of the wood itself do and beat irregularly. Wood and teeth, wood and timber, timber sections and comb the silo slot between the constant friction, impact, compression and split, causing bark and trunk is broken down quickly and split, so as to achieve efficient peeling effect.
Trough-type peeling machine for wood also now can meet the production requirements, but because the single roller length limit stripping efficiency difficult to further improve.
Label：debarker
